Create a Tripod quickly and easy with this designated adaptor. It has three attachment points to quickly create a free-standing tripod on any terrain. Comes with the ability to add a hook and weight for stability if needed.
Perfect for any day session, the CarpLife 1.4L Thermal Flask will keep its contents hot for long periods.
Buy a Hunter 750 Bait Boat and get a Rudgemonkey Hunter 750 Rucksack worth £69.99 Free of Charge
Complimenting the Helical range of carp rods, we have three models of SPM. These are designed to be used as both Spod and Marker rods and are made to the same exacting standards with the same carbons as the carp rods, a combination of Hankook and Toray...
Weston Carbon handle knob conversion with alloy end caps and matching spigot. Shimano Ultegra 14000/5500 XTD XSD, Ultegra Ci4 14000/5500 XTB XSC, Power Aero 14000 XTB XSB, Speedmaster XTB, Med & Big Longcast XTB, Aerlex 10000 XTB, MgS 14000 XTC Ultegra 14000 Ci4+ XTC & XSC etc
Spend £350.00 or more to qualify for 0% Interest Finance.
Only available to UK residents over 18, subject to terms and conditions.
More information
Type your email address here to be notified when this product is available.
New Carbon handle knob conversion with alloy end caps and matching spigot. Shimano Ultegra 14000/5500 XTD XSD, Ultegra Ci4 14000/5500 XTB XSC, Power Aero 14000 XTB XSB, Speedmaster XTB, Med & Big Longcast XTB, Aerlex 10000 XTB, MgS 14000 XTC Ultegra 14000 Ci4+ XTC & XSC etc
Supplied with anodised spigot choose colour from list.
(Handle and Spigot supplied only)
Swapping the original moulded plastic knob fitted as standard could not be simpler which can be done in the comfort of your own living room using a small Philips screw driver & pick tool.
Simply remove the chrome cover from the standard knob by placing a pick tool or small flat screw driver under one end and gently lifting. Once removed this will reveal a small Philips screw, undo the screw and slide off the original moulded knob then using the screw driver gently tease both factory bearings or bushes (depending on model) from the original knob along with the shim washers. Fit one bearing or bush into the end of the new spigot which will face the reel arm and slide back on to the reel arm shaft then fit the washers followed by the second bearing / bush on to the shaft and into the spigot and tighten the screw. Finally once the spigot is mounted to the shaft screw the alloy knob on turning clockwise and nip up by hand. The washers may not be required on re assembly.
Our replacement carbon knobs are manufactured from an UK made carbon and are machined by hand and assembled by us and measure 45mm x 18mm.
Spend £350.00 or more to qualify for 0% Interest Finance.
Only available to UK residents over 18, subject to terms and conditions.
More information
This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Find out more here.
