The new ESP Quickdraw 4K retractable rods are built on high modulus blanks with a crisp responsive action and feature a 3K woven finish on the butt and a lighter 1K finish on the tip – hence the name 4K.
The extra buoyant Zig Float allows zig hookbaits to be instantly adjusted to fish closer to the surface or deeper in the water column to search until carp are located.
The second new Pinpoint pattern for 2025, developed from the original Brute but refined with a parallel point to enlarge the gape and suit bigger hookbaits and shrink tube extensions to improve hook holds under high loading – particularly around snags and heavy weed.
The second new Pinpoint pattern for 2025, developed from the original Brute but refined with a parallel point to enlarge the gape and suit bigger hookbaits and shrink tube extensions to improve hook holds under high loading – particularly around snags and heavy weed.
Weston Carbon knob and spigot conversion for Daiwa 35/45 SCW QD,Basia 45 SCW,Emblem Spod SCW QD, 18 Ninja LT, and similar.
Spend £350.00 or more to qualify for 0% Interest Finance.
Only available to UK residents over 18, subject to terms and conditions.
More information
Type your email address here to be notified when this product is available.
Carbon knob and spigot conversion for Daiwa 35/45 SCW QD,Basia 45 SCW,Emblem Spod SCW QD, 18 Ninja LT, and similar. Please check your handle knob unscrews before ordering.
Supplied with black anodised spigot
(Handle and Spigot supplied only)
Swapping the original moulded plastic knob fitted as standard could not be simpler which can be done in the comfort of your own living room using a small Philips screw driver & pick tool.
Simply remove the chrome cover from the standard knob by placing a pick tool or small flat screw driver under one end and gently lifting. Once removed this will reveal a small Philips screw, undo the screw and slide off the original moulded knob then using the screw driver gently tease both factory bearings or bushes (depending on model) from the original knob along with the shim washers. Fit one bearing or bush into the end of the new spigot which will face the reel arm and slide back on to the reel arm shaft then fit the washers(note washers may not be required on assembly) followed by the second bearing / bush on to the shaft and into the spigot and tighten the screw. Finally once the spigot is mounted to the shaft screw the alloy knob on turning clockwise and nip up with a 10mm spanner.
Our replacement Carbon knobs are manufactured from an UK made carbon and are machined and assembled by us. They measure 45mm x 18mm.
Spend £350.00 or more to qualify for 0% Interest Finance.
Only available to UK residents over 18, subject to terms and conditions.
More information
This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Find out more here.
